Assessment of biowaste composting process for industrial support tool development through macro data approach.

This study aims to assess composting efficiency and quality of compost through the study of the parameters of the Catalan Waste Agency (ARC) data-base by developing indicators useful for industrial sector. The study includes 17 composting plants for an 8-years period (2010-2017), the quantities of materials treated and generated in these plants: biowaste, yard trimmings, refuse and compost, as well as chemical characterization of compost: moisture, total organic matter, organic nitrogen, pH, electrical conductivity, self-heating test, pollutants and ammonium. Plant were sorted into 4 size classes depending on size capacity and into 4 technologies employed during thermophilic phase. Different indicators were developed related to improper fraction content, yard trimmings ratio, mass losses, compost production, refuse generation and plant saturation. The main average results indicate that improper fraction is 10%, process losses 68%, refuse generated 25% and saturation 79%. Differences were observed in size and technology; for instance, smaller plants presented lower improper content, refuse and saturation and higher losses while plants with turned windrows during decomposition presented higher improper, yard trimmings ratio and plants with vessel technology showed lower losses and higher saturation. Also, the compost quality is higher if the plant saturation and improper fraction are below 90% and 7%, respectively. The indicators were useful to assess the process and were related to the compost quality obtained.

The implementation of the Plan Esperanza and response to the imPACT Review.

Following the implementation of the National Cancer Prevention and Control Results-based Budget Programme (PpR Cancer-024) in 2011, the Peruvian Government approved the Plan Esperanza-a population-based national cancer control plan-in 2012. Legislation that ensured full government-supported funding for people who were otherwise unable to access or afford care and treatment accompanied the Plan. In 2013, the Ministry of Health requested an integrated mission of the Programme of Action for Cancer Therapy (imPACT) report to strengthen cancer control in Peru. The imPACT Review, which was executed in 2014, assessed Peru's achievements in cancer control, and areas for improvement, including cancer control planning, further development of population-based cancer registration, increased prevention, early diagnosis, treatment and palliative care, and the engagement and participation of civil society in the health-care system. This Series paper gives a brief history of the development of the Plan Esperanza, describes the innovative funding model that supports it, and summarises how funds are disseminated on the basis of disease, geography, and demographics. An overview of the imPACT Review, and the government's response in the context of the Plan Esperanza, is provided. The development and execution of the Plan Esperanza and the execution of and response to the imPACT Review demonstrates the Peruvian Government's commitment to fighting cancer across the country, including in remote and urban areas.

Agroindustrial compost as a peat alternative in the horticultural industry of Ecuador.

This work was conducted in order to investigate the possibility of using different agroindustrial composts in the production of horticultural seedlings, thereby replacing part of the peat in the growing media. Three vegetable species differing in salt sensitivity - tomato (Solanum lycopersicum L. var. Malpica) (the least sensitive), courgette (Cucurbita pepo L. var. Mastil F1) (moderately sensitive) and pepper (Capsicum annuum L. var. Largo de Reus Pairal) (the most sensitive) - were grown in nine media containing three composts, prepared by co-composting vegetable waste (flower, broccoli or tomato waste) with laying hen manure and sawdust, as well as peat in various ratios. The proportions of the three composts in the mixtures elaborated with peat were 25%, 50% and 75% (v/v). A substrate of 100% peat was used as control. The experiment was arranged in a completely-randomised design, with two replicates per treatment, under greenhouse conditions. Prior to sowing, some physical, physico-chemical and chemical properties of the growing media were determined and the seed germination and fresh and dry weights of the aerial parts and roots of the seedlings were also measured, as well as the mineral composition of the aerial parts of the plants. In most cases, the addition of compost to the growing media produced an increase in the pH, salt content and macronutrient concentrations, in comparison to peat, whereas the physical properties of the compost based-substrates had values very similar to those of an ideal substrate. Also, multivariate analysis showed that the media prepared with flower waste compost, at all concentrations, and the medium with tomato waste compost at 25% were the most suitable substrates for the three plant species tested.

Nitrification during extended co-composting of extreme mixtures of green waste and solid fraction of cattle slurry to obtain growing media.

Next generation of waste management systems should apply product-oriented bioconversion processes that produce composts or biofertilisers of desired quality that can be sold in high priced markets such as horticulture. Natural acidification linked to nitrification can be promoted during composting. If nitrification is enhanced, suitable compost in terms of pH can be obtained for use in horticultural substrates. Green waste compost (GW) represents a potential suitable product for use in growing medium mixtures. However its low N provides very limited slow-release nitrogen fertilization for suitable plant growth; and GW should be composted with a complementary N-rich raw material such as the solid fraction of cattle slurry (SFCS). Therefore, it is important to determine how very different or extreme proportions of the two materials in the mixture can limit or otherwise affect the nitrification process. The objectives of this work were two-fold: (a) To assess the changes in chemical and physicochemical parameters during the prolonged composting of extreme mixtures of green waste (GW) and separated cattle slurry (SFCS) and the feasibility of using the composts as growing media. (b) To check for nitrification during composting in two different extreme mixtures of GW and SFCS and to describe the conditions under which this process can be maintained and its consequences. The physical and physicochemical properties of both composts obtained indicated that they were appropriate for use as ingredients in horticultural substrates. The nitrification process occurred in both mixtures in the medium-late thermophilic stage of the composting process. In particular, its feasibility has been demonstrated in the mixtures with a low N content. Nitrification led to the inversion of each mixture's initial pH.

Intelligent composting assisted by a wireless sensing network.

Monitoring of the moisture and temperature of composting process is a key factor to obtain a quality product beyond the quality of raw materials. Current methodologies for monitoring these two parameters are time consuming for workers, sometimes not sufficiently reliable to help decision-making and thus are ignored in some cases. This article describes an advance on monitoring of composting process through a Wireless Sensor Network (WSN) that allows measurement of temperature and moisture in real time in multiple points of the composting material, the Compo-ball system. To implement such measurement capabilities on-line, a WSN composed of multiple sensor nodes was designed and implemented to provide the staff with an efficient monitoring composting management tool. After framing the problem, the objectives and characteristics of the WSN are briefly discussed and a short description of the hardware and software of the network's components are presented. Presentation and discussion of practical issues and results obtained with the WSN during a demonstration stage that took place in several composting sites concludes the paper.

Heavy metal content in rubbish bags used for separate collection of biowaste.

The heavy metal content of several rubbish bags used to collect the organic fraction of municipal solid waste (OFMSW) is shown in this paper. Nowadays, several public awareness campaigns carried out by municipalities have promoted rubbish bags based mainly on their appearance, without concern for their heavy metal content. A high amount of heavy metals was detected in some polyethylene bags promoted in different campaigns for OFMSW source-sorted collection, while compostable bags presented low quantities of heavy metals. Some other rubbish bags, as well as commercial bags, were also analysed for comparison. These results should be taken into account before promoting the use of one or other type of bag. Moreover, the rubbish bag manufacturers should reduce the heavy metal content in order to avoid heavy metal scattering in the environment, and also to reduce the consumption of raw materials.

An assessment of the characteristics of yard trimmings and recirculated yard trimmings used in biowaste composting.

The aim of this research was to characterise samples of yard trimmings (YT) and recirculated yard trimmings (RYT) that are used to co-compost organic fraction of municipal solid waste (OFMSW) taken from 18 composting facilities in Catalonia (NE Spain), to determine their contribution in the composting process, and to highlight the advantages and disadvantages of reusing RYT. We found significant differences between the characteristics of the two materials. RYT had higher pH levels, electrical conductivity, and organic and ammonium nitrogen content than YT. Nutrient content also shows an increment from YT to RYT, and in the case of P and K, this variation can be attributed to an exogenous source rather than the relative concentration during the composting process. We also found significant differences in particle size distribution and bulk density. From the results, it can be assumed that RYT could be reused in the composting process if OFMSW, YT, and RYT are used in the correct quantities to balance the mixture but they cannot totally replace the features of YT.

Bulk density determination as a simple and complementary tool in composting process control.

Ten composting facilities (CF) treating source-sorted organic fraction of municipal solid waste (OF) were sampled to study the relationship between the bulk density and the composting process (CP) development. Hundred and fourteen samples from different stages of the CP were considered (organic fraction, initial mixture, final decomposition, final maturation and compost), including the reject materials coming from the densimetric table at postprocessing. Total organic matter (TOM), moisture content (MC), wet bulk density and dry basis (BDd) were determined. Significant differences were detected for MC, TOM and BDd between some stages of the CP. The BDd increased along the CP while TOM decreased. Correlation studies showed a significant negative relationship between TOM and bulk density, especially BDd, during the CP, as a result of the biological activity. Moreover, a clear relationship was also found between TOM and BDd in samples related to reject materials. The results indicate that bulk density could be a simple and useful tool to evaluate the CP, in addition to the others parameters commonly used. At the same time, BDd could be an easy way to infer TOM lost within rejects.